Content Wrapper

[Gunnys GXP]

So I didn't like the fact that at intersection cars coming from the sides had no idea which way I was trying to go. After taking a close look I came up with this.

I took off the side markers and set in three single amber LED's (spaced evenly across the top 2/3rds of the side markers) The markers are deep enough for them to fit flush into the drilled out holes on the back side of the markers without going through the front. Then I resealed over them and the holes with weatherproof clear silicone. The wires run between the marker and the body panel they clip in to and then out at the bottom and spliced into each of the front blinkers (negative to the black and possitive to the light blue for each side).

This is a clip to a short vid.
http://s153.photobucket.com/albums/s...erBlinkers.flv

And a couple pics.





Also, I picked up an extinguisher from Walmart for 10 bucks and the lipped section of the floorspace on the passenger side was a perfect spot to mount it. The exhaust pipe is under that hump (no wires or lines to hit with the screws) and it does not interfeer with a passenger. I hate them on the a-pillars. They create more blind spots but I wanted one in there for the just in case and with some of the routes we take here on our club runs I figure it an added plus to have along with my first aid kits.




and finaly, as some of you know I have had 10" blue neons mounted behind my Norms fiberglass fenders. I decided to add one more to the engine bay to enhance a hood up night display (fits perfect on the hood heat shield right at the down slope of the front side of the air box). It's is wired into the same switch as all the rest I have installed.


All the pictures are 13 to 16kb's each so I'm sorry but I don't get why the first two are sooooo dang huge.