I used the Dejon Elbow, two silicone couplers and fourT-Clamps on this install.
Silicone couplers and T-Clamps were ordered from Stylin Motors that has a banner on the forum. Address:
www.stylinmotors.com Their sevrice was excellent.
Inside diameter: 2 3/4 inches. You should satisfy yourself this is correct.
If you order from them...On the Stylin Motors website go to the left side menu and click on couplers, find your inside diameter and color, the quanity and then near the bottom T-Bolt Clamps and select the correct size and quanity.
With the Dejon Elbow you will receive two hard black rubber couplers. Measure each of them them and then add 1/8th inch and mark this on the silicone couplars with a marker.
Now using around a 1 inch peice of masking tape wrap it around the coupler so it is perfectly stright.
Take a new single edge razor blade and just slice it around the coupler following the edge of the masking tape. This is very easy to do on silicone.
Photo below shows what I am talking about. Install photos and approximately 5 minute install proceedure follows on another post to to this thread. PUTFILE giving me a hard time getting in.
