Kenny's Stock RedLine Dyno Results

[kennysabarese]

So I dyno'd my car bone stock, before i got the GMPP Upgrade Kit installed this morning. The results are a bit higher than I expected. I didn't get any boost numbers since I wasn't in the drivers seat and when I did look over the DIC was saying something about traction control, even though I had turned everything off (held the button for 10 seconds to get "ESC off" message)

I know very little about the technicals with dyno's so I will just state everything I know

Crazy Horse Racing
South Amboy, NJ
10:37am
4/10/2009
Nearest Airport is Newark International EWR
Elev: 10 feet
Temp: 52F
Dewpoint: 26
Pressure: 30.05
Dyno Type: Dynojet

<b>Dyno Run 2</b>
<b>SAE</b>
RPM = 1.61
SAE Max Horsepower: 241.1
SAE Mac Torque: 247.7
<b>STD</b>
RPM = 1.85
STD Max Horsepower: 248.7
STD Max Torque: 255.5

<b>Dyno Run 3</b>
<b>SAE</b>
RPM = 1.61
SAE Max Horsepower: 238.8
SAE Mac Torque: 253.3
<b>Standard</b>
RPM = 1.86
STD Max Horsepower: 246.3
STD Max Torque: 261.2

Here are the printouts, one for STD, one for SAE.

[JeffInDFW]

Damn....for a stock tune, that is outstanding! I will watch for you to post your dyno numbers after the GMPP tune! Be sure to wait until you have 10 key cycles so you know it has learned up all the way.

[kennysabarese]

Yeah, I'll be back on the dyno on May 2nd.

[shabby]

Originally Posted by LatinVenom Folks remember this is a Dynojet and are usually high.

I wish mine were higher then...