[TX08manualGXP]

I just noticed that my wipers move at the same speed on low and on high. They work fine on intermittant and they seem pretty slow on low but don't move any faster on high. Tried it at a dead stop as well as different speeds and it's the same. Is there a calibration for this perhaps?

 

[TomatoSoup]

No calibration.... but looking at the circuit, the difference between intermittent/low and high is the wiper relay, which is switched 'on' on the high setting. Make sure that relay is good and not frozen in the low (off) position. (Relay #52)

If the relay is good, then it might be the wiper motor.

 

[TX08manualGXP]

update on this. all seems fine now. I did have the battery disconnected the night before and it's possible not everything had a chance to reset. will keep the above in mind though in case it happens again.